![]() To load everything that is needed, add this to /etc/modules: #-cut here- # Chip drivers coretemp nct6775 #-cut here- If you have some drivers built into your kernel, the list above will contain too many modules. (YES/no): YES Do you want to scan for Super I/O sensors? (YES/no): YES Do you want to probe the I2C/SMBus adapters now? (YES/no): YES Sudo service fancontrol start Reading out the temperaturesĬommand: sensors Setting the threshold values sudo pwmconfig Ubuntu 20.04: There are no pwm-capable sensor modules installed sudo sensors-detectĭo you want to scan for them? This is totally safe. Installing fancontrol sudo apt-get install fancontrol lm-sensors Using the service fancontrol the speed of the fan can be linked to any sensor and any threshold and controlled automatically. In the BIOS I could set the speed, but the automatic mode did not work properly. After I installed a fan in my NAS, it always ran at top speed. Sudo apt install libkf5config-dev libkf5auth-dev libkf5package-dev libkf5declarative-dev libkf5coreaddons-dev libkf5dbusaddons-dev libkf5kcmutils-dev libkf5i18n-dev libkf5plasma-dev libqt5core5a libqt5widgets5 libqt5gui5 libqt5qml5 extra-cmake-modules qtbase5-dev libkf5notifications-dev qml-module-org-kde-kirigami2 qml-module-qtquick-dialogs qml-module-qtquick-controls2 qml-module-qtquick-layouts qml-module-qt-labs-settings qml-module-qt-labs-folderlistmodel cmake build-essential gettext gitĬmake. Install the build requirements (tested in Ubuntu 18.04): sudo apt update Furthermore it communicates with systemd via dbus to control the fancontrol service. It uses the KAuth module of the KDE Frameworks 5 to write the generated config file. Fancontrol-gui is a GUI for fancontrol which is part of lm_sensors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |